10

11

12

Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Follow the instructions in “Closing the server case” on page 44.

Reconnect all power cords and peripheral device cables, then turn on the server.

Installing a hard drive

Use this procedure to add or replace a hard drive in a hot-swap bay. Your server supports as many as three 1-inch high, 3.5-inch hot-swap SCSI hard drives. You can purchase additional drives through your Gateway Sales or Customer Care representative.

Important Gateway tests and verifies the operation and compatibility of the drives it sells. Especially in a hot-swap or mission-critical environment, additional or replacement drives must conform to Gateway standards.

To install a hot-swap hard drive:

1 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

Caution Before you remove a failed drive, use the appropriate software and utilities installed on the server to stop all activity on the failed drive. Instructions for using the software are provided by the software manufacturer. Failure to do so may destroy the data on the drive.

2 Press the green release button on the hot-swap tray lever, then swing the lever open all the way.

3 Pull the drive carrier straight out of the server.

60

www.gateway.com