Follow the instructions in “Opening the server case” on page 42.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

11 Remove the two screws securing the interposer board to the back of the CD or DVD drive, then remove the interposer board.

12

13

14

15

Follow the instructions in “Installing a CD or DVD drive” on page 58.

- OR -

Install a slim-line drive bay filler panel into the empty bay.

Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Follow the instructions in “Closing the server case” on page 44.

Reconnect all power cords and peripheral device cables, then turn on the server.

Installing a CD or DVD drive

To install a CD or DVD drive:

1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

Caution The CD or DVD drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged.

2

3

4 Remove the CD/DVD drive carrier by pressing the blue lever at the back of the carrier and pushing the carrier out the front of the server.

58

www.gateway.com