6 Disconnect the USB connector from the control panel module, then slide the module forward and remove it from the chassis.

Caution The USB header has a latch to hold the connector on. Be careful to unlatch the USB connector when removing it from the control panel or you could damage the connector or the header.

Important The position of the USB connector is different in the standard control panel than in the optional local control panel. Note the positions of the cable connectors as you remove them from the module.

7 Disconnect the front panel cable from the control panel module.

To install the control panel module:

Important Replacing the standard control panel module with the optional LCP control panel module requires the removal of the right hot-swap hard drive.

1 Connect the front panel cable to the new control panel module.

2 Guide the front panel cable into the control panel opening in the chassis, then slide the new control panel module into the chassis far enough to let you connect the USB cable.

Optional LCP control panel module

www.gateway.com

99