
Replacing the control panel module
The steps for replacing the standard control panel module and the optional local control panel (LCP) module, are almost identical and are described in the following steps. Differences in the procedure, where they exist, are noted.
Caution Your server must be operated with a control panel module in place.
Important Correct operation of the optional LCP control panel module requires the optional IMM module. For additional information, see “Installing an Intel Management Module (IMM)” on page 86.
Important Installation of the optional LCP control panel module requires the removal of the right
To remove the control panel module:
1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.
2
3 Unlock the bezel (if necessary) and remove it by pulling it straight out from the front of the chassis.
4 Disconnect the front panel cable from the backplane.www.gateway.com | 97 |