Unlock the bezel (if necessary) and remove it by pulling it from the chassis. Follow the instructions in “Opening the server case” on page 42.

11 If you are replacing the drive, follow the instructions in “Installing a diskette in a converted hard drive bay” on page 52.

12

13

14

- OR -

Install an empty hard drive carrier into the empty hard drive bay.

Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Follow the instructions in “Closing the server case” on page 44.

Reconnect all power cords and peripheral device cables, then turn on the server.

Removing a CD or DVD drive

To remove a CD or DVD drive:

1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

Caution The CD or DVD drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged.

2

3

4 Disconnect the 44-pin CD drive cable from the system board. See “System board” on page 6 for the location of the connectors on the system board.

56

www.gateway.com