Connect the data and power cables to the interposer board.

9 Open the connector on the back of the diskette drive by pulling up on the connector cover.

10 Insert one end of the 26-pin diskette drive flat flex cable into the connector, then push down on the connector cover to lock it into place.

11 Install the other end of the flat flex cable to the interposer board included in the diskette drive conversion kit.

Interposer board

12 Install the interposer board on the diskette drive carrier with one screw on the right side.

13

14 While guiding the cables, insert the new drive assembly into the center hard drive bay until it clicks into place.

54

www.gateway.com