
Check | Diagnostic LED decoder | Description | |||
point | G=Green, R=Red, O=Orange |
| |||
|
|
|
|
|
|
D6 | R | O | G | R | Both key sequence and |
|
|
|
|
| determine if BIOS recovery is forced. Main BIOS checksum is |
|
|
|
|
| tested. If BIOS recovery is necessary, control flows to checkpoint |
|
|
|
|
| E0. See Bootblock Recovery Code Checkpoints section of |
|
|
|
|
| document for more information. |
|
|
|
|
|
|
D7 | R | O | G | O | Restore CPUID value back into register. The |
|
|
|
|
| interface module is moved to system memory and control is given |
|
|
|
|
| to it. Determine whether to execute serial flash. |
|
|
|
|
|
|
D8 | O | R | Off | R | The Runtime module is uncompressed into memory. CPUID |
|
|
|
|
| information is stored in memory. |
|
|
|
|
|
|
D9 | O | R | Off | O | Store the Uncompressed pointer for future use in PMM. Copying |
|
|
|
|
| Main BIOS into memory. Leaves all RAM below 1 MB |
|
|
|
|
| |
|
|
|
|
| SMRAM. |
|
|
|
|
|
|
DA | O | R | G | R | Restore CPUID value back into register. Give control to BIOS |
|
|
|
|
| POST (ExecutePOSTKernel). See “POST code checkpoints” on |
|
|
|
|
| page 128 for more information. |
|
|
|
|
|
|
- | - | - | - | OEM memory detection/configuration error. This range is |
reserved for chipset vendors and system manufacturers. The | ||
error associated with this value may be different from one | ||
| ||
| platform to the next. | |
|
|
Bootblock recovery code checkpoints
The bootblock recovery code gets control when the BIOS determines that a BIOS recovery needs to occur because the user has forced the update or the BIOS checksum is corrupt. The following table provides the diagnostic LED codes for these checkpoints and describes the type of checkpoints that may occur during the Bootblock recovery portion of the BIOS:
Check | Diagnostic LED decoder | Description | |||
point | G=Green, R=Red, O=Orange |
| |||
|
|
|
|
|
|
E0 | R | R | R | Off | Initialize the floppy controller in the super I/O. Some interrupt |
|
|
|
|
| vectors are initialized. DMA controller is initialized. 8259 interrupt |
|
|
|
|
| controller is initialized. L1 cache is enabled. |
|
|
|
|
|
|
E9 | O | R | R | G | Set up floppy controller and data. Attempt to read from floppy. |
|
|
|
|
|
|
EA | O | R | O | Off | Enable ATAPI hardware. Attempt to read from ARMD and ATAPI |
|
|
|
|
| CDROM. |
|
|
|
|
|
|
EB | O | R | O | G | Disable ATAPI hardware. Jump back to checkpoint E9. |
|
|
|
|
|
|
132 | www.gateway.com |