Installing a processor

The server is compatible with Intel® Xeon processors with an 800 MHz front side bus speed and a processor speed of 2.8 MHz or faster. The server automatically detects the processors each time you turn on the server. Whenever you install new processors, you should first install the most current version of the BIOS. For instructions, see “Updating the BIOS” on page 109.

Warning Processors and heat sinks may be hot if the computer has been running. Before replacing a processor or heat sink, allow them to cool for several minutes.

Caution

A heat sink must be installed on the processor. Installing a processor

 

without a heat sink could damage the processor.

 

 

Important You must have a processor in the Processor 1 socket, or your server will not start.

If you are upgrading your server from one processor to two, you may need to reconfigure your operating system so it can recognize the additional processor. For instructions, see your operating system’s documentation.

Important If you install two processors onto the system board, the processors must be the same speeds, revision, core voltage, and bus speed.

To replace a processor:

1 Install the most current BIOS version. For instructions, see “Updating the BIOS” on page 109.

2 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

82

www.gateway.com