Follow the instructions in “Opening the server case” on page 42.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis. Remove the center hot-swap hard drive carrier from the server.
Installing a diskette in a converted hard drive bay

If you need to install a slim-line diskette drive into your server, you must install the diskette drive in the center hard drive bay.

To install a diskette drive in a converted hard drive bay:

1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

Caution

The diskette drive is not hot-swappable. Before installing or removing

 

the drive, make sure that power is turned off and the power cord is

 

unplugged.

 

 

2

3

4

5 xxxRemove the rails from the diskette drive conversion kit carrier by removing the four screws that secure the rails to the carrier.

52

www.gateway.com