Remove the cables from the interposer board.
Disconnect the power cable from the back of the interposer board.
Follow the instructions in “Opening the server case” on page 42.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

15 Connect the other end of the data cable to the system board. See “System board” on page 6 for the location of the connectors on the system board.

16

17

18

Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Follow the instructions in “Closing the server case” on page 44.

Reconnect all power cords and peripheral device cables, then turn on the server.

Removing a diskette drive from the converted hard drive bay

To remove a diskette drive from the converted drive bay:

1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

Caution

The diskette drive is not hot-swappable. Before installing or removing

 

the drive, make sure that power is turned off and the power cord is

 

unplugged.

 

 

2

3

4 Disconnect the data cable from the system board. See “System board” on page 6 for the location of the connectors on the system board.

5

6 Push in on the blue lever at the back of the drive carrier to release the drive carrier from the drive bay, then slide the diskette drive carrier and cables out through the front of the server.

7

8 Remove the single screw securing the interposer board to the drive carrier, then remove the interposer board.

9 Remove the four screws securing the rails to the carrier, then remove the rails. (See the illustration on page 52.)

10 Remove the two screws securing the diskette drive in the carrier, then slide the drive out of the carrier.

www.gateway.com

55