
Configuring the RJ-45 serial port
The
To change the RJ-45 serial port configuration to DCD signal support:
1
2
Turn off the server, then disconnect the power cords and all other cables connected to the server.
Follow the instructions in “Opening the server case” on page 42.Caution Moving the jumper while the power is on can damage your server. Always turn off the server and unplug the power cords and all other cables before changing the jumper.
3 Remove the PCI riser assembly by following the instructions in “Removing and installing the PCI riser assembly” on page 69.
4 Remove the jumper across pins
5
6
Reinstall the PCI riser assembly by following the instructions in “Removing and installing the PCI riser assembly” on page 69.
Follow the instructions in “Closing the server case” on page 44.www.gateway.com | 23 |