GE 49-8338 installation instructions MsTkLLAmoNmsTRucTIoNs, ~o~~~~~l~~ suRFacEBURNERSON

msTkLLAmoNmsTRucTIoNs ,

(continued)

LPorifice spuds are in a small plastic bag packed D with this Use and Care book. LP orifice spuds

a~o~~~~~l~~ suRFacEBURNERSON

MOBELSEQU!PPEBWITH smLEn BURHEB (see sP@p4 if ramgois @quipp@dwith dualburneK.)

BurnerCap

OrificeSpud

GasInletTube

(( —, 1 .

1.Removegrates, burner caps and burner heads.

2.Removeburner bases by unscrewing the 3 small screws in each base. ~ bmner strai&t out.

DO N~ disconnect the wires from the burner bases unless the cooktop needs to be raised.

3. Remove the brass orifice spud under each burner base by unscrewing sp~d fi-omfitting with a 7mm or 5/16” wrench (depending on the size of

your spuds). Apply a 3/4” wrench to the hex on the gas inlet tube as a back-up when removing spud to prevent the aluminum tube from twisting.

4. Install orifice spuds accordin to one of the

fol~owingdiagrams (see ❑ or B), for LP d

gas or natural gas, depending on which you are converting to.

have a 2-digitnumber and the Letter “L”on one side, Each ofice spud will also have 1 or 2 grooves on one side, denoting the location on the range where it is to be installed.

wII‘Frontof.angw

Natural gas ofice spuds have a 3-digitnumber on one side. Each orifice spud willalso have 1,2 or 3 grooves on one side, denoting the location on the range where it is to be installed.

Front of Range

o‘-

D

42