GE 49-8338 installation instructions TOOLS~~~u!~~m

TOOLS~~~u!~~m

T-10T’orxdriver(for sealed burners) 1/2” and 3/4” open-end wrench Flat blade screwdriver (small)

Nut drivers or wrenches: 7rnm or 5/16” (depending on the size of the spuds)

❑PREPMEMHGE FORCOHWERSROH

(1)Twn offgas supp~ at tie wall.

(2)Tmn offtie electicd powe; to tie mgee

Ifrange has not yet been connected to gas supply, or if flexible connection was made, range maybe pulled out from the wall to make conversion easier.

W~G: Do not removethe pressure regulatorfrom the range.

1.For models equipped with sealed burners, remove the storage drawer, broiler drawer or kick panel and locate the pressure regulator at rear of the range.

RemoveScrews

AccessCover

On some models,youmayhaveto removean accesscoveralso.

For models equipped with dual burners, remove the cooktop and locate the pressure regulator at right rear of range.

2.FOUOWthe directions in ❑~ or 0~ that match your regulator type.

1sthe eina ation.

—

Ifit is this regulator:

1.Use a cointo removethe capfromthe pressureregulator.

2.Turn the capoverand hookit intothe slots. The typeofgas to be used shouldnowbe visible onthe top ofthe cap.

❑Note:Onsomemodelsthe shut-offvalve maybein a differentlocation.

thisprotectivecap -	Cap Assembly
exceptfor conversion

Ifit is this regulato~

1.Unscrewthe plastic-protectedhex-nutcap fromthe regulator.

2.Carefullypry the protectiveplasticcapoff the threadedmetalcap.Gentlypullthe plastic washeroffthe threads on the other side ofthe metalcap.

3.Push the plasticcapontothe end ofthe metal capdisplayingthe typeofgas you are converting to. Press the attachedplasticwasherontothe threads on the other side ofthe metalcap.

4.Screw the hex-nutcapback intothe regulator. Donot overtighten.

(continuednextpage)