Gigabyte 7014 user manual APPLYING POWER Side View, page 13 of

APPLYING POWER (Side View)

∙ Unscrew & Remove the DC Voltage Input Plug from the Power Input Header

∙ Install the DC Power Cables into the Plug (observing polarity).

∙ For best results keep the power cable length to a maximum of one (1) meter.

∙ Plug the Voltage Input Plug back into the Power Input Header.

∙ Tightening torque for the terminal block power plug is 0.5 Nm/0.368 Pound Foot.

∙ Verify the Power LED stays ON (GREEN).

Note: Only 1 power supply must be connected to power for minimal operation. For redundant power operation, V1 and V2 inputs must be connected to separate DC Voltage sources. This device will draw current from both sources simultaneously. Use 16-28 gauge wire when connecting to the power supply.

Recommended 24V DC Power Supplies, similar to: N-Tron’s P/N NTPS-24-3:

∙	Input AC 115/230V	∙	Power 72W
∙	Output DC 24-28V	∙ 35 mm DIN-Rail Mountable
∙ Output Current 3A @ 24V		∙	Dimensions: 45X75X91 mm
	2.6A @ 28V

Rev. 051208 page 13 of 152