Gigabyte 7014 Set Priority Level, Show Configuration, Show Intruders, Show Link Utilization

Set Priority Level

Command Name	port set prioritylevel
Description	Sets the priority level of a given port.
Syntax	port set prioritylevel <port-no><level>
Parameters	port-no
	port number (1 ~ 14)
	level
	priority level (0 ~ 7)
Examples	N-TRON/Admin#[1]> port set prioritylevel 6 7
NOTES	Priority State should be enabled to use this feature.
Show Configuration
Command Name	port show config
Description	Displays basic configuration settings on given ports.
Syntax	port show config <port-no all>
Parameters	port-no all
	port number (1 ~ 14), you may enter all to see all the ports at once.
Examples	N-TRON/Admin#[1]> port show config all
NOTES	Check whether port-nois in the valid range. (1 ~ 14)
Show Intruders
Command Name	port show intruder
Description	Displays a list of MAC addresses that were not allowed on the network.
Syntax	port show intruder
Parameters	None
Examples	N-TRON/Admin#[1]> port show intruder
NOTES	Intruder log must be enabled before this will log anything.
Show Link Utilization
Command Name	port show linkutilization
Description	Shows the utilization statistics for all the ports including %bandwidth, %in,
	%out, RX bytes, and TX bytes for each port.
Syntax	port show linkutilization
Parameters	None
Examples	N-TRON/Admin#[1]> port show linkutilization
NOTES	%Bandwidth is the %in or %out value that is higher, not the average value.
Get Flow Control
Command Name	port get flowcontrol
Description	Displays the current flow control settings on a given port.
Syntax	port get flowcontrol <port-no>
Parameters	port-no
	port number (1 ~ 14)
Examples	N-TRON/Admin#[1]> port get flowcontrol 6
NOTES	Check whether port-nois in the valid range. (1 ~ 14)
Get Name
Command Name	port get name
Description	Displays the name of a given port.
Syntax	port get name <port-no>
Parameters	port-no
	port number (1 ~ 14)
Examples	N-TRON/Admin#[1]> port get name 6
NOTES	Check whether port-nois in the valid range. (1 ~ 14)

Rev. 051208 page 117 of 152