NOTES:
1.N-Ring Manager cannot have RSTP or Trunking enabled.
2.RSTP & N-Ring are different modes and cannot share links or segments along those lines. See the examples in the RSTP configuration section.
3.Do not use Trunking on a switch that is directly in an active N-Ring.
4.Any one 7014 can only participate in one N-Ring.
5.N-Ring copper ports must be run at 100Mb full duplex, including the default ‘autonegotiate’ as long as all switches in the ring support 100Mb full duplex.
The “N-Ring Mode” is one of three, as below:
If N-Ring Mode is “Manager”, then a pull-down allow s selection as available of ports P11 and P12, or GB1 and GB2 as N-Ring ports if GB1 and GB2 are populated. Otherwise only P11 and P12 will be offered as a selection.
Rev. 051208 | page 62 of 152 |