Gigabyte 7014 user manual Get Pvid, Clear Counters, Clear Intruder Log

Get PVID

Command Name	port get pvid
Description	Displays a given port’s VLAN-ID.
Syntax	port get pvid <port-no>
Parameters	port-no
	port number (1 ~ 14)
Examples	N-TRON/Admin#[1]> port get pvid 6
	PVID of port 6 is 4.
NOTES	Check whether port-nois in the valid range. (1 ~ 14)
Clear Counters
Command Name	port clear counters
Description	Clears all the numbers in the counters for a given port. These are counters
	for RX bytes and TX bytes and so on.
Syntax	port clear counters <port-no>
Parameters	port-no
	port number (1 ~ 14)
Examples	N-TRON/Admin#[1]> port clear counters 6
	Counters of Port[6] are : [cleared]
NOTES	This will clear all data in the port specific counters. This data cannot be
	recovered after this step.
Clear Intruder Log
Command Name	port clear intruderlog
Description	This command will clear all intruders out of the intruder log.
Syntax	port clear intruderlog
Parameters	None
Examples	N-TRON/Admin#[1]> port clear intruderlog
NOTES	This will clear all data from the intruder log. This data can not be
	recovered after this step.

Rev. 051208 page 119 of 152