Gigabyte 7014 Configuration Related Commands, Save Configuration, Load Default Configuration

Configuration Related Commands

Save Configuration

Command Name	config save
Description	The configuration will be saved to the flash.
Syntax	config save
Parameters	None
Examples	N-TRON/Admin#[1]> config save
NOTES
Load Default Configuration
Command Name	config erase
Description	This command is useful to erase the configuration data
Syntax	config erase
Parameters	None
Examples	N-TRON/Admin#[1]> config erase
	Load Factory Default Setting. [y/n]y
	Factory Default Configuration Successfully loaded
	Restart the switch to effect this change
NOTES	This command will reset all configurable fields back to the default settings
	that the switch shipped with. This will change the IP address back to
	192.168.1.201 and will change the slot configurations of the 7014 to all
	9006TX modules and no gigabit fiber ports.
Configuration Upload
Command Name	config send
Description	The configuration on the flash is grouped into a file and sent to the tftp
	server.
Syntax	config send <Server-IpAddress> <File-Name>
Parameters	Server-IpAddress
	IP Address of the TFTP Server, to where the switch configuration data
	will be uploaded.
	File-Name
	Name of the file to be saved as.
Examples	N-TRON/Admin#[1]> config send 10.1.6.151 config
NOTES	The ip address should be the valid tftp server ip address, and the target tftp
	server should be running.
Configuration Download
Command Name	config receive
Description	The file name mentioned will be downloaded from the server and the same
	configuration is overwritten to the flash.
Syntax	config receive <Server-IpAddress> <File-Name>
Parameters	Server-IpAddress
	IP Address of the TFTP server, from where the configuration data to be
	retrieved.
	File-Name
	Name of the file to be retrieved.
Examples	N-TRON/Admin#[1]> config receive 10.1.6.151 config
NOTES	The ip address should be the valid tftp server ip address, and the target tftp
	server should be running.

Rev. 051208 page 139 of 152