Henny Penny OFG-391 manual Oil Tmp, Cpu Tmp, Analog 1

			Model OFG- 391
3-19. INFORMATION MODE	Press	and “6. PMP_ AIR_” shows in display.
(Continued)
	Press	to view the amp “DRAW” status of the pump motor
	output and air valve output. “PMP ” and “AIR ” in the
	display means the amps are good. Aflashing “X” behind the
	“PMP” or “AIR” means too much current.
	Press	to view the No Connect/Ground (“NC/GND”)
	status of each output. This monitors a possible problem with
	the relays on the output PC board.
	Press	to continue onto the OIL TMP reading.
	7. OIL TMP
	This step shows the present peanut oil temperature. The
	display shows “7. OIL TMP (temp.)”.
	Press	to continue onto the CPU TMP reading.
	8. CPU TMP
	This step shows the present PC board temperature.
	Press	to continue onto the ANALOG reading.
	9. ANALOG <1> 2.86V
	This step displays the present status of any channel of the
	controller’s a to d converter. This feature may be useful to a
	technician troubleshooting a problem with the fryer or
	controller.
	The displayed value can be toggled between volts and bits
	by pressing . If the displayed value has a decimal point,
	it is voltage (0 to 5 VDC). If no decimal point is shown, the
	value is a-to-d bits (0 - 4095).
		Press and hold	to exit Information Mode at any
		time, or after 2 minutes, controls automatically exit
		back to normal operation.
3-42			703