Henny Penny OFG-391 manual Special Program, Mode

			Model OFG- 391
3-17. SPECIAL PROGRAM	The Special Program mode is used to set more detailed
MODE	parameters listed below.
	SP-1	· Degrees Fahrenheit or Celsius
	SP-2	· Language: English, French, German,
	SP-3		Spanish, and Portuguese
		·	Systeminitialization
	SP-4	·	Audio volume
	SP-5	·	Audio tone
	SP-6	· Type of shortening to be melted - liquid, solid
	SP-7	·	Idle Mode
	SP-8	·	FilterTracking
	SP-9	·	Product buttons
	SP-10	·	Clean-out minutes
	SP-11	·	Clean-out temperature
	SP-12	·	Nominal amps reading
	SP-13	· Amps reading low limit (percentage)
	SP-14	· Amps reading high limit (percentage)
	SP-15	· Program code change
	SP-16	· Usage code change
	SP-17	· Change shortening - A-Cook Cycles
	SP-18	· Change shortening - B-Hours

1.Press and hold for 5 seconds until

“L-2” and “LEVEL 2”, followed by, “SP PROG” and “ENTER CODE shows in the display.

2.Enter code 1, 2, 3, and “SP- 1 “, “TEMP, UNITS” shows in the display.

If a bad code is entered, an alarm sounds and “BAD CODE” shows on the display. Wait a few seconds, the control reverts back to the Cook Cycle, and repeat the above steps.

To exit from the Special Program Mode at any time, press

and hold button for 2 seconds, or to roll back to

previous setting, press .

Degrees Fahrenheit or Celsius (SP-1) a. Follow steps 1 and 2 above.

	b. The display flashes “SP- 1” and “TEMP, UNITS”, along
	with “ºF” or “ºC”. Press
	buttons to toggle from “ºF” to “ºC”, or vice versa.
1005	3-29