HP Deskjet 6800 series printer

Ethernet network without an Internet connection

In this example, the network devices are connected to a hub. Devices use AutoIP to obtain IP addresses.

4.3.3 Installing the printer on an Ethernet network

Installing the printer on an Ethernet network is a two-part process.

First you must connect the printer to the network. Then you must install the printer software on each computer that will use the printer.

Connecting the printer to an Ethernet network

Installing the printer software

4.3.4Connecting the printer to an Ethernet network

Follow these steps to connect the printer to an Ethernet network: 1. If necessary, set up the printer hardware.

For printer hardware setup instructions, see the setup poster that came with the printer.

2.Verify that the printer is powered on.

3.Connect the Ethernet cable to an available port on the network hub or router.

Note: Do not plug the Ethernet cable into a port labeled WAN or Uplink. 4. Connect the Ethernet cable to the Ethernet port on the back of the printer.

49

Page 49
Image 49
HP 6800 manual Ethernet network without an Internet connection, Installing the printer on an Ethernet network