HP Book 6000 manual Removing an Sdram Module, Sdram Module Replacement Part Numbers

Removing an SDRAM Module

(User-Replaceable)

The OmniBook 6000 has no SDRAM on its motherboard, but has two slots for that hold two SDRAM modules. One slot contains a SDRAM module installed at the factory.

Table 2-4. SDRAM Module Replacement Part Numbers

Description

SDRAM module, 32-MB (100 MHz)

SDRAM module, 64-MB (100 MHz)

SDRAM module, 128-MB (100 MHz)

SDRAM module, 256-MB (100 MHz)

Part Number

1818-7950

1818-7951

1818-7952

1818-7953

Exchange Part Number

F1660-69103

F1660-69104

F1654-69101

Caution

Handle the SDRAM module only by its edges and provide proper grounding, or you might damage the board by electrostatic discharge.

Required Equipment

∙Small Phillips screwdriver.

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery. Remove the secondary battery if one is installed.

2.Turn the unit bottom-side up, loosen the screw holding the SDRAM cover (the cover retains the screw), and remove the cover.

3.Release the two latches at the sides of the SDRAM module, so the free edge of the board pops up.

4.Pull the board out of the connector.

Figure 2-5. Removing a SDRAM Module

Reassembly Notes

∙Gently press the SDRAM module into the connector at about a 30° angle, until it is fully inserted. Then press down on both sides until the latches snap closed.

2-6 Removal and Replacement HP OmniBook 6000