HP Book 6000 manual Removing the Hard Disk Drive, Hard Disk Drive Replacement Part Numbers

Removing the Hard Disk Drive

(User-Replaceable)

Table 2-5. Hard Disk Drive Replacement Part Numbers

Description

Drive, hard disk (5 GB, 9.5 mm, Hitachi)

Drive, hard disk (6 GB, 9.5 mm, Hitachi)

Drive, hard disk (6 GB, 9.5 mm, IBM)

Drive, hard disk (10 GB, 9.5 mm, IBM)

Drive, hard disk (12 GB, 9.5 mm, Hitachi)

Drive, hard disk (18 GB, 12.7 mm, IBM)

Part Number

0950-3825

0950-3732

0950-3710

0950-3831

0950-3733

0950-3712

Exchange Part Number

F2072-69103

F1660-69108

F1711-69106

F2072-69104

F1660-69107

F1660-69106

Required Equipment

∙Small Phillips screwdriver.

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery. Remove the secondary battery if one is installed.

2.Turn the unit bottom side up and remove both hard drive screws.

3.Raise the cover on the end of the drive so that its retainer tab is free of the computer casing, then gently pull the hard drive out of the computer.

Screws, M2.5×4mm (2)

Figure 2-6. Removing the Hard Disk Drive

4.Remove all six screws from the holder and drive case, then lift the drive out of the holder.

5.Notice that the hard drive has a pin connector attachment at one end. Carefully remove this connector from the end of the drive. Work alternately at each end so that the connector slides off evenly without bending the connector pins.

HP OmniBook 6000 Removal and Replacement 2-7