HP Book 6000 manual Removing the Display Reassembly Notes

Screws, M2.5×6mm (4)

Label with DIP switch settings

Screws, M2.5×6mm (2)

Screws,

M2.5×6mm (5)

Figure 2-10. Removing the Display

Reassembly Notes

∙Before installing any screws, make sure the center hinge cover fits over the tab in the bottom case.

Important

∙Make sure the DIP switches on the display interface PCA match the settings shown on the label on the display cable, or you risk damaging the display.

∙If you change the DIP switches, you must also reprogram the EEPROM for the new display— see page 2-26. If the EEPROM is not programmed correctly, the display will not turn on.

2-14 Removal and Replacement HP OmniBook 6000