HP Book 6000 manual Troubleshooting the Problem, Verifying the Repair

Models: Book 6000

1 96
Download 96 pages 36.89 Kb
Page 55
Image 55

Troubleshooting the Problem

Record pertinent information about the unit:

Model and serial number.

Operating system and version.

BIOS version.

Accessories and peripherals used. Analyze the problem:

Observe Symptoms. Using the customer’s information, try to duplicate the problem. Determine how the problem differs from proper behavior. Also, take note of the functions that do work properly.

Separate Problems. If there is more than one symptom, separate them into distinct problems.

Consider Causes. Keep in mind possible causes for each problem. Use the diagnostic tools and troubleshooting suggestions to help find possible causes.

çThe DiagTools diagnostic program tests most components of the OmniBook’s components using automatic and interactive tests, and will be your primary troubleshooting tool. Other tools include the power-on self-test, DMI/TopTools (if installed), the BIOS Setup utility, and the Sycard PCCtest. The table on page 3-4 shows how you can use these tools to isolate the cause of the computer’s problem.

çThe troubleshooting suggestions on page 3-5 include general suggestions for repairing units with specific failure symptoms.

Swapping modules that may be defective with others known to be good is generally an ideal way to find the module responsible for the problem. A failure symptom is rarely caused by more than one module, so you will not usually need to replace more than one module to correct a particular failure.

After you replace a module, the computer will normally be in a confused state and lock up when you apply power. If this happens, press the system-off switch: this resets the computer and starts it in a known state.

Verifying the Repair

Before returning the repaired unit to the customer, verify the repair by running the following tests:

DiagTools Basic Diagnostic Test. Run the basic test of the DiagTools diagnostic program (page 3-14).

–and–

Function Tests. Run tests that check the repaired function, such as in the DiagTools diagnostic program (page 3-14).

–and–

Failed Tests. Run any other tests that failed during troubleshooting.

HP OmniBook 6000

Troubleshooting and Diagnostics

3-3

Page 55
Image 55
HP Book 6000 manual Troubleshooting the Problem, Verifying the Repair