4.Carefully separate the sensor assembly (callout 1) from the product, pass the wire harness through the hole in the chassis, and then remove the assembly.

NOTE: Pass the connector and wire harness through the hole in the chassis. See Figure 1-125 Remove the color-misregistration sensor assembly PCA (2 of 4) on page 91.

Figure 1-127Remove the color-misregistration sensor assembly PCA (4 of 4)

Reinstall the color-misregistration sensor assembly

TIP: You might have to attempt this reinstall procedure several times before you successfully pass the connector through the hole in the chassis.

1.Push the sensor assembly wire-harness connector into the hole in the chassis from the ITB side of the product.

Figure 1-128Reinstall the color-misregistration sensor assembly PCA (1 of 2)

92 Chapter 1 Removal and replacement

ENWW