HP CLJ M375NW PRO 300 CE903A#BGJ, M475 CE863A manual Network Setup menu

Network Setup menu

In the following table, items that have an asterisk (*) indicate the factory default setting.

Menu item		Sub-menu item	Sub-menu item	Description
Wireless Menu		Wireless Direct Settings	Wireless Direct On/Off	Enables or disables the Direct Wi-Fi wireless access
NOTE: You can also				feature.
			Wireless Direct Name	Set the product's Direct Wifi name, so you can access it
access this menu by
touching the Wireless				from other wireless devices that support the Wi-Fi Direct
	button on the control			protocol.
panel.
			Wireless Direct Mode	Set the product's Direct Wifi mode.
				●	Select the Print Only option (the default setting) to
					allow wireless access to only the product print
					functions from a mobile device.
				●	Select the Open Network option to allow wireless
					access to all product functions and settings from a
					mobile device.
		Wireless Setup Wizard		Guides you through the steps to set up the product on a
				wireless network
		Wi-Fi Protected Setup		If your wireless router supports this feature, use this method
				to set up the product on a wireless network. This is the
				simplest method.
		Run Network Test		Tests the wireless network and prints a report with the
				results.
		Turn Wireless On/Off		Enables or disables the wireless network feature.
TCP/IP Config		Automatic*		Automatic: The product automatically configures all the
		Manual		TCP/IP settings via DHCP, BootP or AutoIP.
				Manual: You can manually configure the IP address,
				subnet mask, and default gateway. The control panel
				prompts you to specify values for each address section. As
				each address is completed, the product prompts for
				address confirmation before moving to the next one. After
				all three addresses are set, the network reinitializes.
Auto Crossover		On*		Enables or disables the use of a standard 10/100 network
		Off		cable when the product is directly connected to a
				computer.
Network Services		IPv4		Enable or disable the IPv4 and IPv6 protocols. By default,
		IPv6		each protocol is enabled.
Link Speed		Automatic*		Sets the link speed manually if needed.
		10T Full		After setting the link speed, the product automatically

restarts.

10T Half

100TX Full

100TX Half

ENWW Troubleshooting tools 151