Table 2-9Secondary service menu (continued)

Menu item

Sub-menu item

Description

 

 

 

Memory Cards (fax/memory-

Enable

This item enables or disables the product memory-card functions.

card models only)

Disable

 

 

 

 

 

 

Color Calibrate

Adjust Color

This item adjusts density settings for contrast, highlights, midtones, and

 

 

shadows. Adjust each color individually.

 

 

 

 

Timing

This item specifies how frequently the product should automatically

 

 

perform a color calibration. The default setting is 48 hours. You can turn

 

 

automatic calibration off.

 

 

 

Clean Belt

 

This item runs additional belt-cleaning cycles.

 

 

 

Pick Roller

 

This item puts the pickup roller in position for replacement.

 

 

 

Product resets

The product resets—Restore Defaults and the NVRAM initialization—perform the same function. If possible, use the Restore Defaults function in the Service menu. If that menu is not accessible, use the NVRAM sequence.

Restore the factory-set defaults

NOTE: Before restoring defaults, print a menu structure report and a configuration page. Use the information on these pages to reset customer-specific settings.

CAUTION: All onboard network settings are also reset. Be sure to print a configuration page before restoring defaults. Make note of the IP address that is listed on the Jetdirect configuration page. You might need to restore the IP address after restoring the defaults.

1.Touch the Setup button.

2.Open the Service menu.

3.Touch the Restore Defaults item. The product automatically restarts.

NVRAM initialization

Performing an NVRAM initialization resets the following settings and information:

●All menu settings are reset to factory default values.

●All localization settings, including language and country/region, are reset.

CAUTION: All onboard network settings are also reset. Be sure to print a configuration page before restoring defaults. Make note of the IP address that is listed on the Jetdirect configuration page. You might need to restore the IP address after an NVRAM initialization.

ENWW

Service mode functions 213