HP CommonIO Products Table, Table, (Continued), Description, X.3 Parameter

				PAD Services
			X.3 Parameter Descriptions
Table 6-3		(Continued)
		16	ETX and EOT only.
		32	HT, LT, VT, FF only.
		64	NUL, SOH, STX, BS, LF, CR, SO, SI,
			DLE, DC1, DC3, DC4, NAK, SYN,
			ETB, EM, SUB, FS, GS, RS, and US
			(all other characters in the first two
			columns of the International
			Alphabet #5).
		126	All characters, except
			alphanumerics.
		127	All characters are data forwarding.
NOTE		The values listed for parameter 3 may be combined by specifying the sum
		of the values. For example, specifying 10 is the same as specifying 2 and
	8.

Table 6-4

X.3 Parameter	Description
4 - Idle Timer	Specifies a timer duration interval in units of
	1/20 of a second. If the time between characters
	entered at the terminal exceeds the specified
	timer value, the packet being assembled by the
	PAD is automatically transmitted. The range is 0
	through 255. If 0 is specified, there is no idle
	timer and packets will never be transmitted due
	to a time-out.
5 - Anc Device	The ancillary device control parameter permits
Control	flow control toward the terminal by the PAD. The
	PAD indicates its readiness to receive characters
	from the terminal by transmitting X-ON (DC1) or
	X-OFF (DC3) to the terminal. 0 indicates that
	flow control by the PAD is not operational, and 1
	permits flow control by the PAD.

Chapter 6 167