HP CommonIO Products NOTE, Chapter, Command Summary, Configuration and Troubleshooting Commands

Troubleshooting

Configuration and Troubleshooting Commands

	Configuration and Troubleshooting
	Commands
	This section provides a brief summary of X.25 commands and indicates
	where further information can be found. Examples of x25init and the
	syntax for IP over X.25 mapping are provided at the end of the section.
	Command Summary
NOTE	You can use the x25message utility to get an explanation of an error
	message. Enter the command at the HP-UX prompt followed by the text
	of the message, and the system will display an explanation of the cause
	along with recommendations for corrective action.
	x25init
	Initializes your X.25 link (requires Superuser
	privileges). See your man pages and the examples later
	in this section.
	x25stop
	Gracefully shuts down an X.25 link (requires
	Superuser privileges). See your man pages.
	x25check and x25server
	Together, these commands can be used to test
	connectivity between two nodes up to the X.25 access
	level (level 3). See your man pages and the examples in
	Chapter 5, “Diagnostic Utilities.”
	x25stat
	Displays X.25 link status, configuration information,
	and virtual circuit statistics. See your man pages and
	the examples in Chapter 5, “Diagnostic Utilities.” Some
	options require Superuser privileges.
	x25mibstat

212 Chapter 8