Troubleshooting

Configuration and Troubleshooting Commands

 

 

Because pvc describes a permanent circuit for a

 

 

particular interface, that interface must have been

 

 

initialized prior to the initialization of the address map

 

 

table. If the interface or the specified PVC does not

 

 

exist, an error is reported.

 

prog_access

 

 

_name

Specifies the card's programmatic access name.

 

 

 

NOTE

For Series 712 workstations this is always

 

 

name=interface0.

 

+URC

Specifies that outbound calls to this IP address will

 

 

 

Use Reverse Charging (URC).

 

-URC

(Default) Specifies that outbound calls to this IP

 

 

address will not Use Reverse Charging (URC).)

 

+ARC

Specifies that inbound calls to this IP address will

 

 

Accept Reverse Charging (ARC).

 

-ARC

(Default) Specifies that inbound calls to this IP address

 

 

will not Accept Reverse Charging (ARC).

x25_card_device A device configured for one of your existing X.25 cards. This information is used by the IP_to_X25 software to identify the interface port through which the outbound packets will be sent.

CUG=n

Specifies the Closed User Group index number used for

 

placing calls to this IP address. The index number is a

 

two- or four-digit number. Two digits corresponds to

 

the basic format, and four digits corresponds to the

 

extended format of the CUG selection facility.

#

You can put comments in your IP mapping table by

 

including the # character at the beginning of the line.

 

Note that you cannot add comments after a table entry.

Chapter 8

217