HP CommonIO Products Step, Step, Table, Verifying Level 3 Values, Modify IP over X.25 Defaults Field Descriptions

			Configuration
			Configuring the X.25 Link
		Enter or modify field values as required (refer to the field descriptions
		below).
Table 3-5		Modify IP over X.25 Defaults Field Descriptions
		Idle Timer	Sets the number of seconds a circuit stands idle
			before it is cleared by IP. The range is 0 to 32767.
			The default is 600.
		Hold Timer	Sets the number of seconds a circuit may be
			inactive before it is designated as inactive.
			Inactive circuits may be cleared when all other
			circuits are unavailable and a connection request
			is received by IP. Do not set the hold timer to a
			value greater than the idle timer. The range is 0 to
			32767. The default is 300.
		MTU Size	The maximum transmission unit size in octets
			(bytes). The range is 20 to 8192. The default is
			2048. For DDN configured interfaces, it must be
			less than or equal to 1007.
		System Max. IP	The maximum number of IP connections that can
		Connections	be simultaneously active for the whole system.
			This is a global parameter. The default value for
			this parameter is 256 connections.
Step	5. Click on OK to return to the “Configure X.25 Card” window when you
		have finished configuring the Internet address.
		Verifying Level 3 Values
		If you subscribe to a public network, the network provider will supply the
		appropriate settings for most level 3 parameters. These settings will
		differ depending on the network provider and the type of service to which
		you subscribe. Refer to your Network Subscription Form for the correct
		values for your configuration.
		Follow the steps below to verify level 3 values:
Step	1. At the “Configure X.25 Card” window, select Verify Level 3 Values.
		The following dialog appears:

Chapter 3 39