01201138 |
| 0108 |
| 3 | 13 |
| INSTRUCTION |
Notice |
| Date | Page | 13. Maintenance | |||
|
| HANDBOOK | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Error/Function |
|
|
| Cause |
| Action | |
|
|
|
| ||||
| Error 11 |
|
| ||||
UNBAL SENSOR FAULT |
|
| |||||
|
|
|
|
|
|
|
|
The unbalance safety device has been activated before spinning.
-The unbalance safety contact has been activated for at least 5 seconds during washing before a distribution.
-The unbalance safety contact fautly or a suspen- sion spring is broken.
-Bad loading of machine.
-Turn the machine's wall switch off and check unbalance safety contact.
-Check suspension.
-Correctly load the drum or put linen in several nets.
NO INVERTER COMM. | Error 13 |
| |
|
|
|
|
Communication between PCU | - Transient fault. No action required. | - Turn the machine's wall | |
and frequency converter inter- |
| switch off and on again. Start a | |
rupted or disturbed. |
| program. | |
|
| - Frequency converter faulty. | - Check the frequency converter. |
LEVEL CALIBRATION Error 14
The water level system has not been correctly calibrated.
-If the level system has not been calibrated at the factory the error message will appear for fi ve seconds immediately after every program
-Carry out programming anew and make sure the calibration values are within the allowed limits.
EMERGENCY STOP Error 15
The emergency stop button has - Abnormal or dangerous running of the machine. been pressed.
-After the problem which caused the emergency stop has been put right, reset the emergency stop button by turning it until it pops back out.
-Check wiring.
DOOR LOCK Error 17
signal absent from door status | - Transient fault. No action required. |
switch, although door is locked. |
|
-Check if the door is locked.
-Open the door and switch off power to machine. Wait a minute or so, switch on power supply, close door again and try restarting.
- Fault in door lock switch or in wiring faulty. | - Check wiring or replace door |
- The PCB is faulty. | lock as appropriate. |
- Replace PCB. |
START NOT ALLOWED Error 18
The network does not allow start . of the washing programme.
-Try to reset the error code. If the error remains, contact the responsible person for the network and have the error fi xed.
