0107 43 11

Notice Date Page
01201138
INSTRUCTION
HANDBOOK
11. Machine
operation
Press SELECT.
Check that "RESET SCALE
TO ZERO" is highlighted.
If it isn't...
Press or as required to
highlight "RESET SCALE TO
ZERO".
This screen shows that the
weighing equipment has been
reset to zero.
Press SELECT.
Reset scale to zero (for machines with weighing equipment installed only)
Reset scale to zero
Reset weighing equipment” is used to make the weigh-
ing equipment display 0 when the machine has no load
in it.
If your attempt to reset the weighing equipment fails at
this point, you will see an error message equivalent to
"FAILED. PRESS SELECT" on the display. For trou-
bleshooting, see the section "Fault-fi nding, weighing
equipment" in the machine manual.
Please note :
The machine must be unladen when you use this func-
tion, i.e. no water or wash load in the drum.
Please note :
After a power-cut, the weighing equipment will always
display 0, no matter what the actual load in the drum.
In this event you will have to use the "Reset scale to
zero" function.
SCALE ADJUSTMENTS
SELECT
RESET SCALE TO ZERO
DONE !
PRESS SELECT
SELECT
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SET TARE TO A CERTAIN VALUE
READ TARE VALU E
CALIBRATE THE SCALE
ZERO CALIBRATION
READ VERSION NUMBER
EXIT
SERVICE PROGRAM
MAKE A CHOICE :
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SET TARE TO A CERTAIN VALUE
READ TARE VALUE
CALIBRATE THE SCALE
SELECT
SELECT