INSTRUCTION

HANDBOOK

11. Machine

01201138

0107

66

11

operation

Notice

Date

Page

 

After a power-cut

2

 

When the supply is restored after a power- cut, the weight display will show "0" if the load inside the drum is less than 6.25 kg. If the load weighs more than 6.25 kg, the true weight of the load will be shown.

Normal mode

RUN A WASH PROGRAM

GO TO THE MENU

MAKE YOUR CHOICE WITH

￿OR ￿ PRESS SELECT

WEIGHT, KG 000,0

Water level reduction

To achieve optimum load volumes, the weight of the load can be seen on the dis- play while the machine is being loaded. If the machine does not have a full load, the water level will be reduced according to a water-level reduction table. The water level can never be any lower than the safety level plus the hysteresis.

 

 

SELECT

 

 

Reset to zero

Menu line showing

 

actual weight

3651

3

Weight display mode

Actual weight display

Fig. The Clarus control unit automatically detects

2if weighing equipment is connected, and the actual (current) weight is shown on the dis- play, on one line of the menu (normal display mode).

Fig. When the machine starts to be loaded,

3the display switches to showing the actual weight in large numerals (weight display mode).

Normal display mode is resumed :

If a new program number is entered using the numeric keys.

If is pressed.

Automatically after the time set via "Settings 1" under "Time for weight display".

While a wash program is running, you can switch to weight display mode by select- ing "Show weight", see the section "Show weight" under "Machine operation".

The weight shown on the display will always be the net weight (achieved because the weighing equipment has been "tared"). A slight delay is built in to prevent the display from fl ickering.

CLARUS CONTROL

WEIGHT, KG :

097,0

4775

Page 135
Image 135
Electrolux WS4250H, WS4650H, WSB4250H, WS4500H, WSB4350H, WS4350H, WSB4650H, WSB4500H manual 097,0