Removal and Replacement Procedures— Small Form Factor (SFF) Chassis

7.13.2Type 2 Battery Holder

1.To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery 1. When the battery pops up, lift it out.

2.To insert the new battery, slide one edge of the replacement battery under the holder’s lip 2 with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery.

✎After replacing the battery, use the following steps to complete this procedure.

3.Replace the computer cover or access panel.

4.Plug in and turn on power to the computer.

5.Using Computer Setup, reset the date and time, passwords, and any special system setups. For more information, refer to the Computer Setup (F10) Utility Guide.

 

Service Reference Guide, dx5150

361685-001

7–27