5.Connect the appropriate drive cables:

a.If installing a second hard drive, connect the power cable (1) and data cable (2) to the rear of the drive and connect the other end of the data cable to the light blue connector on the system board labeled SATA1.

Figure 7-23Connecting the Secondary Hard Drive Power Cable and Data Cable

b.If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA.

Figure 7-24Connecting the Media Card Reader USB Cable

NOTE: Refer to System Board Connections on page 105 for an illustration of the system board drive connectors.

6.Replace the 5.25-inch drive.

7.Replace the front bezel (if removed) and access panel.

8.If the computer was on a stand, replace the stand.

114 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis