5.Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided eight extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric guide screws are black. Refer to Drives on page 63 for an illustration of the extra M3 metric guide screws location.

NOTE: When replacing the drive, transfer the four M3 metric guide screws from the old drive to the new one.

CAUTION: Use only 5-mm long screws as guide screws. Longer screws can damage the internal components of the drive.

Figure 6-18Installing Guide Screws (Optical Drive Shown)

6.Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until the drive snaps into place.

Figure 6-19Sliding the Drives into the Drive Cage

68 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis

Page 76
Image 76
HP E3S33UT#ABA, E3S36UT#ABA, Pro 6305 C1E21UT#ABA manual