Control panel message | Description | Recommended action |
|
|
|
Jam in output bin | The product has detected a paper jam in the |
| output bin area. |
Clear the jam from the area indicated in the message, and then follow the control panel instructions.
Jam in print paper path | The product has detected a paper path jam. | Clear the jam from the area indicated in the |
|
| message, and then follow the control panel |
|
| instructions. |
|
|
|
Jam in tray 1 | The product has detected a jam in the input | Clear the jam from the area indicated in the |
| tray. | message, and then follow the control panel |
|
| instructions. |
|
|
|
Load tray 1 <TYPE>, <SIZE> | The tray is empty. | Load the tray with the correct type and size of |
|
| paper. |
|
|
|
Load tray 1 PLAIN <SIZE> | The product is performing a cleaning cycle. | Load the tray with plain paper of the size |
alternates with |
| indicated. Press the OK button to start the |
| cleaning cycle. | |
Cleaning Page [OK] to start |
|
|
|
|
|
Manual duplex | The product is processing a manual duplex | To print the second side, place the pages |
alternates with | job. | face down in the tray with the top edge first. |
|
| |
Load tray 1 |
|
|
Press [OK] |
|
|
|
|
|
Manual feed <SIZE>, <TYPE> | The product is set for the manual feed mode. | Load the tray with the correct size and type of |
alternates with |
| paper, or press the OK button to use the |
| paper that is in the tray. | |
Press [OK] for available media |
|
|
|
|
|
Memory is low | The product does not have enough memory | If the product is processing other jobs, send |
Press [OK] | to process the job. | the job again after those jobs have finished. |
| If the problem continues, turn off the power | |
|
| |
|
| by using the power switch, and then wait at |
|
| least 30 seconds. Turn on the power and wait |
|
| for the product to initialize. |
Memory is low. Only 1 copy made. Press [OK] to continue.
Product memory is too low to complete this job.
Either copy fewer pages at a time or turn off collation.
If the error persists, turn the product off, and then on.
Misprint | The product has experienced an internal |
Press [OK] | hardware error. |
|
1.Reprint the pages.
2.If the error persists, turn the product off, and then on.
3.Print the pages again.
4.If the error persists, contact HP. See www.hp.com/support/ljm1530series or the support flyer that came in the product box.
ENWW | Interpret control panel messages 211 |