Manual configuration

Only the IPv4 protocol can be configured manually.

1.On the control panel, press the Setup button.

2.Use the arrow buttons to select Network Setup, and then press the OK button.

3.Use the arrow buttons to select TCP/IP Config, and then press the OK button.

4.Use the arrow buttons to select Manual, and then press the OK button.

5.Use the alphanumeric buttons to type the IP address, and then press the OK button.

6.If the IP address is incorrect, use the arrow buttons to select No, and then press the OK button. Repeat step 5 with the correct IP address, and then repeat step 5 for the subnet mask and default gateway settings.

Automatic configuration

1.On the control panel, press the Setup button.

2.Use the arrow buttons to select Network Setup, and then press the OK button.

3.Use the arrow buttons to select TCP/IP Config, and then press the OK button.

4.Use the arrow buttons to select Automatic, and then press the OK button.

It may take several minutes before the automatic IP address is ready for use.

NOTE: If you want to disable or enable specific automatic IP modes (such as BOOTP, DHCP, or AutoIP), these settings can be changed by using the embedded Web server or HP ToolboxFX only.

Install the software

1.Quit all programs on the computer.

2.Install the software from the CD.

3.Click the HP Installer icon, and follow the onscreen instructions.

4.On the Congratulations screen, click the Close button.

5.Print a page from any program to make sure that the printing software is correctly installed.

Remove software from Mac operating systems

You must have administrator rights to remove the software.

1.Disconnect the product from the computer.

2.Open Applications.

3.Select Hewlett Packard.

4.Select HP Uninstaller.

5.Select the product from the list of devices, and then click the Uninstall button.

6.After the software is uninstalled, restart the computer and empty the Trash.

ENWW

Software for Mac 31