Menu item | Description | |
|
|
|
Archive Print | On | When printing pages that will be stored for a long time, |
| Off | this option sets the product to a mode that reduces |
| toner smearing and dusting. | |
|
| The default setting is Off. |
|
|
|
Firmware Date |
| Displays the current firmware date code. |
|
|
|
Restore Defaults |
| Sets all settings to the factory default values. |
|
|
|
Network Setup menu
Menu item | Description | |
|
|
|
TCP/IP Config | Automatic | Automatic automatically configures all the TCP/IP settings via |
| Manual | DHCP, BootP or AutoIP. |
| Manual requires you to manually configure the IP address, subnet | |
|
| |
|
| mask, and default gateway. |
|
| The control panel prompts you to specify values for each address |
|
| section. Use the arrow buttons to increase or decrease the value. |
|
| Press the OK button to accept the value and move the cursor to |
|
| the next field. |
|
| As each address is completed, the product prompts for address |
|
| confirmation before moving to the next one. After all three |
|
| addresses are set, the product automatically restarts. |
|
|
|
Auto Crossover | On | Sets the auto crossover function. |
| Off |
|
|
|
|
Network Services | IPv4 | Sets whether the product will use either IPv4 or IPv6 protocol. |
| IPv6 |
|
|
|
|
Show IP Address | Yes | Sets whether the product displays the IP address on the control |
| No | panel. |
|
| |
|
|
|
Link Speed | Automatic | Sets the link speed manually if needed. |
| 10T Full | After setting the link speed, the product automatically restarts. |
| 10T Half |
|
| 100TX Full |
|
| 100TX Half |
|
|
|
|
Restore Defaults |
| Resets all network configurations to their factory defaults. |
|
|
|
ENWW | Setup menu 17 |