Required tools

#2 Phillips screwdriver with a magnetic tip and a 152-mm (6-inch) shaft length

Small flatblade screwdriver

Needle-nose pliers

ESD mat (if one is available) or ESD strap

Penlight (optional)

CAUTION: Always use a Phillips screwdriver (callout 1). Do not use a pozidrive screwdriver (callout 2) or any motorized screwdriver. These can damage screws or screw threads.

CAUTION: Avoid pulling directly on wires to disconnect wire-harness connectors. Pull on the plastic body of a connector to avoid damaging the connector wires.

Figure 6-1Phillips and pozidrive screwdriver comparison

ENWW

Required tools 99

Page 111
Image 111
HP P2050 manual Required tools, 1Phillips and pozidrive screwdriver comparison