HP P2050 Load tray 1 Type Size, Manual duplex, Manual feed Type Size, Memory is low, Misprint

Control-panel message	Event code	Description	Recommended action
Load tray 1 <TYPE> <SIZE>		No trays are configured for the	Load the correct media into
Press [OK] for available media		media type and size that the print	tray 1, or press OK to use media
		job is requesting.	in a different tray.
Manual duplex		The first side of a manual duplex	Load the page in the indicated
Load tray x		job has printed, and the page	tray with the side to be printed
		needs to be loaded to process the	face up, and the top of the page
Press [OK]		second side.	away from you and then press
			OK.
Manual feed <TYPE> <SIZE>		The product is set for manual	Press OK to clear the message
Press [OK] for available media		feed mode.	or load the correct media into
			tray 1.
Memory is low		The product memory is almost	Press OK to finish the job, or
Press [OK]		full.	press the Cancel button	to
			cancel the job.
			For information about increasing
			the product memory, see Install
			memory (HP LaserJet P2050
			Series Printers only) on page 64.
Misprint		Print media has been delayed as	Press OK to clear the message.
Press [OK]		it moves through the product.
Non-HP supply installed		A non-HP supply is installed.	If you believe you purchased an
			HP supply, go to www.hp.com/
			go/anticounterfeit.
			Service or repairs that are
			required as a result of using non-
			HP supplies are not covered
			under HP warranty.
Order black cartridge		The print cartridge is nearing the	Order a new print cartridge. You
Ready		end of its useful life.	can continue printing with the
			current print cartridge until
			redistributing the toner no longer
			yields acceptable print quality.
			See Parts and diagrams
			on page 253 for more
			information.
Output bin full		As the output bin accumulates	1. Rotate the output bin
Remove all paper from bin		paper, the output bin delivery flap	delivery flap up and down.
		rises until a flag blocks the	The flap must move freely. If
		photosensor (PS911). When the	the top cover has been
		photosensor is blocked, this	replaced, make sure that it
		message appears.	has been installed correctly.
			2. Make sure that the
			connector at J213 on the
			engine controller PCA are
			seated.
			Remove all paper from the bin.
Rear door open		The product rear door is open.	Close the door.
Remove shipping lock from		A print cartridge shipping lock is	Be sure that the print cartridge
black cartridge		installed.	shipping lock has been removed.

ENWW Interpret control-panel messages (HP LaserJet P2050 Series Printers only) 225