HP P2050 manual Jam in output bin, Jam in Tray

Alert message	Description	Recommended action
Jam in output bin	This error occurs if the duplex reverse	1.	Make sure that the paper meets
	photosensor (PS918) or fusing exit sensor		specifications. See Specifications
	(PS915) detect unexpected paper.		on page 291.
		2.	Open the rear duplex jam-release door
			and clear any visible paper. Verify that
			the duplex-release sensor flag moves
			freely. You might need a pen light to
			observe the flags.
		3.	Open the face-up output door, and verify
			that the exit sensor flag in the fusing
			assembly moves freely. You might need
			a pen light to observe the flag.
		4.	Verify that the following connectors are
			seated on the engine controller PCA:
			◦	J208 duplex reverse
			◦	J206 fusing exit

Jam in Tray 1	The Tray 1 pickup solenoid (SL1) controls the
	feeding of paper from Tray 1. When the
	solenoid is engaged, the Tray 1 pickup roller
	makes one rotation and advances paper into
	the paper path. See Figure 7-3 Components
	on the left side of the product on page 196).

1.Inspect the Tray 1 pick roller. Verify that the roller is installed correctly and in good condition.

2.Print from Tray 1. Determine if the Tray 1 roller rotates. Listen to determine if the solenoid (SL1) is engaged.

		3.	Remove the left cover. Determine if the
			solenoid (SL1) is correctly installed.
			Make sure that the connectors on the
			solenoid and at J4 on the formatter PCA
			are seated.
		4.	If the error persists, replace the Tray 1
			pickup solenoid (SL1). See Tray 1
			pickup solenoid on page 138.
Jam in Tray 2	Solenoid (SL2) controls the feeding of paper	1.	Inspect the Tray 2 pick roller. Verify that
	from Tray 1. When the solenoid is engaged,		the roller is installed correctly and in
	the Tray 1 pick roller makes one rotation and		good condition.
	advances paper into the paper path. See	2.	Remove Tray 2. Lift the Tray 2 paper
	Figure 7-3 Components on the left side of the
	product on page 196).		present sensor flag while printing from
			Tray 2. Determine if the Tray 2 roller
			rotates. Listen to determine if the
			solenoid (SL2) is engaged.
		3.	Remove the left cover. Determine if the
			solenoid (SL2) is correctly installed.
			Make sure that the connectors on the
			solenoid and at J1104 on the connector
			PCA are seated.
		4.	If the error persists, replace the solenoid
			(SL2).

ENWW Status-alert messages (HP LaserJet P2030 Series Printers only) 217