HP P2050 Power-switch assembly, 68Remove the power-switch assembly 1 Removal and replacement

Models: P2050

1 322
Download 322 pages 19.97 Kb
Page 156
Image 156

Power-switch assembly

1.Remove the following components:

Right cover. See Right cover on page 115.

Left cover. See Left cover on page 118.

Rear cover, rear door, and duplex-paper-feed assembly. See Rear cover, rear door, and duplex-paper-feed assembly on page 120.

NOTE: Only the HP LaserJet P2050 Series products have a duplex-paper-feed assembly installed.

Reverse-sensor assembly. See Reverse-sensor assembly; HP LaserJet P2050 Series on page 142.

NOTE: Only the HP LaserJet P2050 Series products have a reverse-sensor assembly installed.

2.Disconnect one connector (callout 1), release the wire harness from the guide (callout 2), and then pass the wire harness through the hole in the chassis (callout 3).

Figure 6-68Remove the power-switch assembly (1 of 4)

3 1

2

144 Chapter 6 Removal and replacement

ENWW

Page 156
Image 156
HP P2050 manual Power-switch assembly, 68Remove the power-switch assembly 1 Removal and replacement