HP P2050 manual Face-down-drive or duplexing-paper-feed assembly

Face-down-drive or duplexing-paper-feed assembly

The HP LaserJet P2030 Series products have a face-down-drive assembly installed.

The HP LaserJet P2050 Series products have a duplexing-paper-feed assembly installed.

These components appear identical from the outside, but they have different internal gears and functions. The same procedure is used to remove either component.

1.Remove the following components:

●Right cover. See Right cover on page 115.

●Left cover. See Left cover on page 118.

●Rear cover, rear door, and duplex-paper-feed assembly. See Rear cover, rear door, and duplex-paper-feed assembly on page 120.

NOTE: Only the HP LaserJet P2050 Series products have a duplex-paper-feed assembly installed.

●Top cover assembly. See Top-cover assembly on page 124.

●Fan. See Fan on page 140.

2.Remove two screws (callout 1), and then release the wire harnesses from the guide (callout 2).

NOTE: You might have to disconnect some of the connectors on the sub PCA to gain enough slack in the wire harnesses to release them from the guide.

Figure 6-120Remove the face-down-drive or duplexing-paper-feed assembly (1 of 4)

2

1

ENWW Internal assemblies 177