HP P2050 manual Fuser, 88Remove the fuser 1 Removal and replacement

Models: P2050

1 322
Download 322 pages 19.97 Kb
Page 170
Image 170

Fuser

CAUTION: The fuser might be hot. Allow enough time for the fuser to cool after the product power is turned off.

NOTE: The cartridge-door assembly should be in the closed position when the fuser is removed to make sure that the fuser-drive gear is correctly aligned for reinstallation.

1.Remove the following components:

Right cover. See Right cover on page 115.

Left cover. See Left cover on page 118.

Rear cover, rear door, and duplex-paper-feed assembly. See Rear cover, rear door, and duplex-paper-feed assembly on page 120.

NOTE: Only the HP LaserJet P2050 Series products have a duplex-paper-feed assembly installed.

Reverse-sensor assembly. See Reverse-sensor assembly; HP LaserJet P2050 Series on page 142.

NOTE: Only the HP LaserJet P2050 Series products have a reverse-feed sensor installed.

2.Disconnect six connectors (callout 1), and then release the wire harnesses from the guide (callout 2).

Figure 6-88Remove the fuser (1 of 7)

21

158 Chapter 6 Removal and replacement

ENWW

Page 170
Image 170
HP P2050 manual Fuser, 88Remove the fuser 1 Removal and replacement