HP P2050 manual Laser/scanner assembly

Laser/scanner assembly

WARNING! ESD sensitive component.

CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.

1.Remove the following components:

●Right cover. See Right cover on page 115.

●Left cover. See Left cover on page 118.

●Rear cover, rear door, and duplex-paper-feed assembly. See Rear cover, rear door, and duplex-paper-feed assembly on page 120.

NOTE: Only the HP LaserJet P2050 Series products have a duplex-paper-feed assembly installed.

2.Disconnect one FFC (callout 1), and then remove the antistatic foam pad (callout 2).

CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.

Figure 6-86Remove the laser/scanner assembly (1 of 2)

2

1

156 Chapter 6 Removal and replacement ENWW