7.Disconnect one FFC (callout 7) and two connectors (callout 7), and then remove two screws (callout 8).

CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.

NOTE: Place a mark on one of the cartridge-door interlock switch wires before you disconnect them, so that you can reconnect the connectors to the same switch lugs.

Figure 6-102Remove the ECU (6 of 14)

7

8

8.Slightly raise the power-inlet side of the ECU. Figure 6-103Remove the ECU (7 of 14)

166 Chapter 6 Removal and replacement

ENWW

Page 178
Image 178
HP P2050 manual Enww