HP P2050 manual Load paper, Manual feed, No paper pickup, Non-HP supply installed, Not Connected

Alert message	Description	Recommended action
Load paper	The product did not detect paper in Tray 1 or	1. Verify that paper is loaded in the input
	Tray 2. PS916 detects paper in Tray 1.		tray.
	PS914 detects paper in Tray 2. See Figure	2. Make sure that the photosensor flags
	7-7 Components in the print cartridge cavity
	on page 199.		are not hindered.
		3.	Make sure that connectors J205 (for
			Tray 1) and J204 (for Tray 2) on the
			engine controller PCA are seated.
Manual feed	The product is set for manual feed mode.	Load the correct paper into the tray, and then
		press the OK button to clear the message.
No paper pickup	The print engine has failed to pick up a piece	Reload the paper in the input tray and press
	of paper.	the OK button to continue the job.
Non-HP supply installed	A new, non-HP supply has been installed.	If you believe you purchased an HP supply,
	This message appears until an HP supply is	go to www.hp.com/go/anticounterfeit.
	installed or you press the OK button.	Service or repairs that are required as a result
		of using non-HP supplies are not covered
		under HP warranty.
		To continue printing, press the OK button.
Not Connected	The product software cannot communicate	1. Make sure the product is turned on.
	with the product.	2.	Make sure the USB cable is connected
			securely to the product and the
			computer.

Order black cartridge	The identified print cartridge is nearing the
	end of its useful life.

Order a new print cartridge. You can continue printing with the current print cartridge until redistributing the toner no longer yields acceptable print quality.

Page too complex	The product cannot process the page.	Press the OK button to continue printing the
		job, but output might be affected.
Printing	The product is printing a document.	Wait for printing to finish.

218 Chapter 7 Solve problems ENWW